The tap water Booster pump can be disassembled first, and then the shell and parts in the Booster pump can be disassembled separately. The middle part of the pump body can be found first, and then the pump body can be cleaned first. The pump body, the connection port and the middle short pipe also need to be cleaned, especially the Booster pump interface. There will be a rotating nut at the interface position, and a rubber pad in the pump. At this time, a large amount of dirt will adhere to the gaps of the rubber pad, and it needs to be cleaned carefully. Usually, ordinary water temperature can be used for flushing.

1. When cleaning the pipe Booster pump, first open the casing of the Booster pump and purge the pump casing with air source.

2. When cleaning the air Booster pump, the pump body should be checked and there should be no obvious scratch damage. If there is, it needs to be replaced.

3. When cleaning the air Booster pump, it is necessary to check the impeller to see if there is corrosion and wear. The cavitation can not exceed the standard. If severe wear or deformation is found, the impeller needs to be replaced with a new one.

4. When cleaning the Booster pump, the appearance of the pump casing should be checked. There should be no cracks and deformation. The joint surface should be smooth and free of damage. Otherwise, it should be repaired or replaced immediately.