As long as a product is used, it is inevitable that during use, such or so large and small problems. How should you solve these problems? Today, as a supplier of a product small self -absorbing pump product, I will introduce the daily use problem solving methods of its main products. Let's take a look at the following.

Small self -absorbing pumps are common in the process of daily use. In the process of daily use, there will be some common problems. For example, there are many different reasons for the non -pumping problem of self -absorbing pumps, so how we should deal with these problems is the key. The causes of self -absorbing pumps do not pump water include several aspects.

For the first time, the self -absorbing pump is used; it means that it does not need to be added when the self -absorbing pump is activated, and its own impeller can be achieved, and the larger the sealing gap of the impeller, the lower the height of its self -suction. This does not mean that it does not need to add water. After the first installation of the self -absorbent pump, you still need to use the impeller of the self -absorbing pump to take the water to suck the water.

The water on the pump is long for a long time; the cause of this situation may be: less water diversion, self -water absorption pump in and out of water, etc. There are screw looseness, insufficient sealing of the water inlet pipe, and less self -absorbing pump itself (the self -absorbing pump itself is small (the self -absorbing pump itself is less suction (self -suction itself ( In this case, you can consider replacing a self -suck pump with a large suction). Self -absorbing pump work is unstable, and frequent short -term stop work. In this case, it is recommended to check whether the physical structure or accessories of the self -absorbing pump is damaged, and whether a foreign body appears inside the self -absorbing pump, such as weeds.

The amount of water out of the pump is small; when the pump is out of water but the water output is not very large, you must first check whether the gap between the impeller and the shell mouth is too large. It is also one of the possible reasons. The other may be that the water flow pipes of the impeller are blocked by foreign bodies, and the fillers are seriously worn.