1) The flow is spacious, and the performance is good, allowing the particle size to reach 10 mm. When pumping mud and impurities, the pump is very small;

2) The pneumatic diaphragm pump does not need to be poured in water. The suction process is as high as 5-9 meters (dry or wet), the raising is 70 meters, and the exit pressure is 7BAR;

3) There is no rotation part of the pneumatic diaphragm pump, no axis seal, and the pumping medium pumping from the diaphragm is completely separated from the motion component and workpiece medium of the pump, and the transmitted medium will not leak outward. Therefore, when pumping toxic, volatile or corrosive media, it will not cause environmental pollution and harm to personal safety;

4) Raising the journey and flow can be regulated without regulation through the air valve opening (the air pressure regulation is between 1-7Bar)

5) Can be soaked in the medium and not working in the medium

6) No need to use electricity, safe and reliable in flammable and explosive places

7) The pneumatic diaphragm pump structure is simple and less damaged. The pump structure is simple, and the installation and maintenance are convenient. The wear of gears, blades and other components gradually decreases performance;

8) It is convenient to use, reliable work, and only need to open and close the gas valve simply. Even if the medium does not run for a long time due to accidents, or suddenly the downtime pump will not be damaged. Once the load is overload, the pump will automatically shut down automatically. , With self -protection performance, when the load is returning to normal, it can automatically start operation;

9) The pneumatic diaphragm pump does not need to be lubricated with oil. Even if it is empty, it has no effect on the pump. This is a major feature of the pump;

10) Can be transported more sticky liquid (the viscosity is below 20,000 %);