1. Cancel the gate valve and the inverse valve. The resistance coefficient of the gate valve and the inverse valve is large. The role of the gate valve is to regulate the amount of water, but the amount of water in the agricultural pump does not need to be adjusted, so it can be saved. The role of the anti -stop valve is to prevent water flow. After the door is shot, there is no need to stop the valve.

2. Cancel the bottom valve. The resistance coefficient of the bottom valve is large, which will generally reduce the raising of about 1.5 meters. The efficiency of the water pump after canceling the bottom valve will be significantly improved. If you put the door on the outlet pipe mouth, block the filler box with butter, so that you do n’t have to fill the water when the pump is started again.

3. Put the pump or turn the pump snail shell. In this way, the entry and exit water pipe can directly enter and exit the pool to reduce the elbow.

4. Reduce the loss of the pipeline filter. Use 0.8 mm steel wire instead of the filter, which can increase the gap between the overwater surface and reduce power consumption.

5. There must be sufficient flooding depth of the water inlet pipe. When the depth is not enough, the water will generate vortex, bring the air into the pump to reduce the efficiency of the pump. The drowning depth of the water pipe during the dry period should be greater than 0.5 meters.

6. Avoid the "high -fire cannon" water outlet method. Because the water outlet pipe is higher than the surface of the pool, the losses are large. The water flowing out of the pipe port will generate reflex waves on the side wall, increasing the pressure of the outlet and affecting the water out of the water.

7. Choose an economic pipe diameter. The resistance loss of the water pipe is inversely proportional to the five steps of the pipe diameter. The smaller the diameter of the water pipe, the greater the resistance.

8. Remove the flow channel blockage in time. If there is impurities blocking the in -out water pipe, impeller or a diversion of the shell, it will reduce the amount of water.

9. Improve the efficiency of belt transmission. Pay attention to the tight edge of the belt and the loose edge of the transmission corner. Do not change the wide belt to a narrow belt during use, and pay attention to the tightness of the belt.